Modular Cabling 

 

Cable installation by using high speed air flow combined with additional mechanical pushing force is called as “blowing or jetting”. Cable blowing is the process of installation of optical fiber cable into a pre-installed duct. Compressed air is injected in the duct inlet after few hundred meters of cable is pushed into the duct. Compressed air flows at high speed through the duct  and along the cable. The pushing force is applied mainly near the cable inlet by a pushing device. Standard optical fiber cables (like uni-tube, multi-tube, unarmored & armored), micro duct cables, and micro-ducts can be installed by using this method. It is possible to install micro duct cable using blowing method in continuous lengths of more than 1000 meters depending up on the duct route.

 


 

 

            

Address : No. 22, Sheikh Moradi Avenue, Habibollah Street , Sattarkhan street , Iran
0098 21 66511619
0098 21 66511441
0098 21 66511466

Fax 0098 21 66502310

 
 info@nbgme.net